Content | TONAR DIAMOND 914DS - N 320D
For Nagaoka C 320 M , Toshiba C 320 Cartridges High Quality Stylus Spherical Diamond for Turntable
Fits the following models:
Specs:
High Quality aftermarket Stylus
Bonded spherical Diamond tip 0.7 mil
Tracking force: : 1,5-2,5 grams, recommended 2,0 grams
Stylus color: Transparent Green
CartridgeL C 320 M
Manufactured in Japan
Compatible also with :
Stylus:
Nagaoka JN105, N320M, N-320D, N-330D, N-30D, C320M, C320 M, N330D
Goldring D982, Soundring D990
Toshiba C320M
Cartridges:
Marantz CT320, TT320,
Nagaoka JT105, C320 M,
Thorn SRA25,
Toshiba N320, N330, N340N, C320, C330, C340M, SR25, SRA25 …and many more…
Fits the following Turntables models: Marantz CT320, TT320,
Nagaoka N320,
Thorn SRA25,
Toshiba N320, N330, N340N, C320, C330, C340M, SR25, SRA25.and more
Note: This needle was installed on the following turntable models when they were sold.
If the original cartridge has been replaced with a different type, this needle won't fit.
Match your old needle to the picture before you make a purchase.
| Stylus 2M Blue
Technical data |
|
Frequency range |
20-25.000 Hz |
Frequency response |
20-20.000 Hz + 2 / - 1 dB |
Tracking ability at 315Hz at recommended tracking force *) |
80 µm |
Compliance, dynamic, lateral |
20 µm/mN |
Stylus type |
Nude Elliptical |
Stylus tip radius |
r/R 8/18 µm |
Equivalent stylus tip mass |
0,5 mg |
Tracking force range |
1,6-2,0 g (16-20 mN) |
Tracking force, recommended |
1,8 g (18 mN) |
Tracking angle |
20° |
Stylus colour |
Blue |
|
|
Recommended for following cartridges |
2M Blue |
*) Typical value | Ortofon 510MKII Stylus Technical Data
- Frequency range20-23.000 Hz
- Frequency response20-20.000 Hz + 2 / - 3 dB
- Tracking ability at 315Hz at recommended tracking force70 µm
- Compliance, dynamic, lateral25 µm/mN
- Stylus typeElliptical
- Stylus tip radiusr/R 8/18 µm
- Equivalent stylus tip mass0,3 mg
- Tracking force range1,25-1,75 g (12,5-17,5 mN)
- Tracking force, recommended1,5 g (15 mN)
- Tracking angle20°
- Stylus colourBlack
- Recommended for following cartridgesSeries 510 Mkll, 510, 510 P
|
|
DJ E Replacement stylus
Basic model for scratch and back-cueing. Outstanding rigidity by extra-strengthened cantilever
Features Special Elliptical stylus and a special developed and extremely balanced cantilever.
Not only does the cartridge have a most sufficient tracking ability, it is also nearly unbreakable and provides the DJs with the most needed stringency. Furthermore, it equals very low record wear, an advantage for busy DJ.
The DJ series has been known to many as the "jack of all trades," with improved tracking, alongside of accurate sound reproduction. Featuring a low wear stylus design, the DJ provides excellent groove handling, even with less weight applied.
DJ E Stylus Technical data
Output voltage at 1000Hz, 5cm/sec. - 6 mV Channel balance at 1kHz - 2 dB Channel separation at 1kHz - 23 dB Channel separation at 15 kHz - 15 dB Frequency range at -3dB - 20-22.000 Hz Frequency response - 20-20.000 Hz +/-2 dB Tracking ability at 315 Hz at recommmende tracking force - 80 μm Compliance, dynamic lateral - 9 μm/m N Stylus type - Special Elliptical Stylus tip radius - r/R 13/25 μm
Tracking force range - 2,0-4,0 g (20-40 mN) Tracking force recommended - 3,0 g (30 mN) Tracking angle - 20° Internal impedance, DC resistance - 750 Ohm Internal inductance - 450 mH Recommended load resistance - 47 kOhm Recommended load capacitance - 200-600 pF Cartridge weight - 18,5 g
Compatible with cartridges - DJ S
| Replacement stylus for the Carl Cox Signature CS-1 Cartridge.
* Frequency response: 20 to 22,000Hz
* Output: 6mV
* Channel separation nominal: 32dB
* DC resistance: 430 ohms/ch
* Inductance: 400mH/ch
* Weight: 18.0g
* Channel balance: within 1.5dB
* Tracking force: 3–6g
* Recommended load: 47K ohms 200pf
* Stylus tip: fine circular diamond
* Application: club and mobile DJs, high output |
Genuine Original Stylus for OM 20, OM 20 Super, OMP20, LM 20, Concorde 20, TM 20
Nude Elliptical
|
Reviews
There are no reviews yet.