LD SYSTEMS LDP82 Passive speaker 8inch 100W RMS

LD Systems PRO 8

8" PA Speaker passive

• 37 Hz to 18 kHz frequency range
  (-10 dB)
• 150W pink noise, 300 watts continuous program power capacity
• 110 x 85 degree coverage with rotatable horn
• 115W, 55W, 28W at 70V/100V (plus 14W taps at 70V only)
• 8 Ohm Bypass
• Outdoor-rated screw down input terminal strip (with MTC-PC2 sealed entrance cover)
• Available in black or white (Control 29AV-WH)
• Dimensions (HxWxD): 518 mm x 305 mm x 280 mm (20.3 in x 12.0 in x 11.0 in)
• Net Weight: 12.2 kg (26.8 lb

Ειδική έκδοση του AM 7200/95 για χρήση σε
εξωτερικό περιβάλλον με επιπλέον αναβάθμιση
14 σημείων. Πιστοποίηση IP55 κατά πρότυπο IEC
529. Παράδοση κατόπιν παραγγελίας.  

* 90° x 50° Coverage, rotatable for use in either vertical or horizontal orientation.

    * CMCD™ Cone Midrange Compression Driver provides low midrange distortion, increased sensitivity, extended bandwidth and improved phase coherency.

    * 2432H High-Frequency Compression Driver

    * PT™ Progressive Transition Waveguide for excellent pattern control with low distortion.

    * Bi-Amp/Passive Switchable.

    * Optional planar array frame kits for a number of array configurations (see AE Series Array Guide).


Frequency Range (-10 dB)       :       260 Hz – 20 kHz

Frequency Response (±3 dB)       :       330 Hz – 18 kHz

Coverage Pattern       :       90°x 50°, rotatable waveguide

Directivity Factor (Q)       :       11

Directivity Index (DI)       :       10.5 dB

Crossover Modes       :       Bi-amp/Passive switchable

Crossover Frequency       :       2.2 kHz

Transducer Power Rating (AES)       :       MF: 350 W (1400 W peak), 2 hrs
HF: 100 W (400 W peak), 2 hrs

Long-Term System Power Rating (IEC)       :       MF/HF: 200 W (800 W peak), 100 hrs

Maximum SPL5       :       Bi-amp mode:
MF/HF: 133 dB-SPL cont avg (139 dB peak)
Passive mode:
MF/HF: 133 dB-SPL cont avg (139 dB peak)

System Sensitivity (1W @ 1m)       :       Passive mode: 108 dB SPL

Nominal Impedance       :       8 ohms

Midrange Driver       :       JBL CMCD-82H Cone Midrange Compression Driver with integral 200 mm (8 in) diameter Differential Drive® dual voice-coil internal driver

Sensitivity (1W @ 1m)
(Midrange)       :       108 dB SPL

High Frequency Driver       :       JBL 2432H, 38 mm (1.5 in) exit compression driver, 75 mm (3 in) voice coil

Sensitivity (1W @ 1m)
(High Frequency)       :       113 dB SPL

Waveguide       :       PT-K95MH

Enclosure       :       Trapezoidal with 15 degree side angles, 16 mm (5/8 in) exterior grade 11-ply Finnish birch plywood

Suspension Attachment       :       13 points (3 top, 3 bottom, 2 each side, 3 rear), M10 threaded hardware

Finish       :       Black DuraFlex™ finish.
White available upon request.

Grille       :       Powder coated 14 gauge perforated steel, with acoustically transparent black foam backing.

Input Connector       :       NL4 Neutrik Speakon® and CE-compliant covered barrier strip terminals. Barrier terminals accept up to 5.2 sq mm (10 AWG) wire or max width 9 mm (.375 in) spade lugs. Speakon in parallel with barrier strip for loop-through.

Environmental Specifications       :       Mil-Std 810; IP-x3 per IEC529.

Dimensions (H x W x D in vertical cabinet orientation)       :       548 x 561 x 657 mm
(21.6 x 22.1 x 25.9 in)

Net Weight       :       27.2 kg (60 lb)

Optional Accessories       :       M10 x 35 mm forged shoulder eyebolts with washers. Optional planar array frame kit. See AE Series Bracket Guide.

The Monitor 88 is the result of extensive research in the development of new transducers and crossover design. The result is a product with exceptional fidelity, the ability to produce deep controlled bass and extended high frequencies without sacrificing efficiency.
The low-frequency 8“driver ʼs low-mass, carbon fiber diaphragm remains extremely rigid at high power levels,producing a more linear response and lower distortion.
The high-frequency section features a constant directivity horn with a built-in mechanical phase equalizer.
The horn is driven by a Ferrofluid® cooled,1“titanium dome tweeter.
All components are housed in a vented enclosure formed from semiexpanded polystyrene foam.
The speaker system is available in black (Monitor 88)or white (Monitor 88W).

• 37 Hz to 18 kHz frequency range
  (-10 dB)
• 150W pink noise, 300 watts continuous program power capacity
• 110 x 85 degree coverage with rotatable horn
• 115W, 55W, 28W at 70V/100V (plus 14W taps at 70V only)
• 8 Ohm Bypass
• Outdoor-rated screw down input terminal strip (with MTC-PC2 sealed entrance cover)
• Available in black or white (Control 29AV-WH)
• Dimensions (HxWxD): 518 mm x 305 mm x 280 mm (20.3 in x 12.0 in x 11.0 in)
• Net Weight: 12.2 kg (26.8 lb)

Powerful monitor-speaker

• Active speaker-system for direct connection with the signal source
• 2-way speaker-system
• Clear and powerful sound
• 2-band EQ master-signal and master-signal
• Wide range of uses in spite of minimum size
• Ideal for decentral sound-surroundings, e.g. in bistros, restaurants, bars or studio
• Delivery includes mounting bracket for ceiling or wall installation

Technical Information: