| Content |
The PHDA02 - a reference class headphone amplifier with Stereo, Mono, and Dual Mono operation modes.
In Stereo mode, the L/R input signal is fed to the left and right earphones while the volume level is set by the Stereo/Left control. The front panel inputs provide simultaneous connection of two headphones in parallel. In Mono mode, the left and right channels are summed, and the resulting mono signal is fed to both the left and right earphones. Again, volume is governed by the Stereo/Left control. In Dual Mono mode, the left and right channels can be used independently with individual level controls for the left and right earphones.
The PHDA02 operates with all headphones with an impedance of 8 up to 200 Ohms. Impedance matching is achieved by a specially designed switchable transformer. Uncommon and costly, this solution provides superior performance, dynamic range, and signal-to-noise ratio at all loads.
Combo input sockets allow for balanced XLR and unbalanced TS headphone connection while parallel XLR outputs facilitate daisy chaining multiple units. The integrated power supply operates with mains from 100 VAC to 240 VAC.
The PHDA02 is equipped with low-noise op amps, and the output amplifiers' discrete power transistors are mounted on heatsinks. Dimensions are 1 U 9.5“.
|
Palmer Monicon, and the volume is right!
With Palmer Monicon, your monitor volume is always under control. The passive mini-mixer with the oversized control is inserted between the stereo output of the notebook, PC or interface and an active monitor system and thus permits convenient and precise volume control of the monitors from the workstation. The passive circuitry with only a few components has absolutely no affect on the sound. Mute and mono buttons make it possible to mute the outputs and merge the stereo output signal into a mono master signal.
The inputs and outputs of the controller are equipped with XLR connectors and the 3.5mm stereo TRS sockets usually found on computers. Combo input sockets also permit connection with 6.3 mm TRS plugs. Thus the Palmer Monicon is compatible with both professional and consumer equipment. Genuine wood sides make the practical studio tool in its massive powder-coated sheet steel housing an elegant looking "little helper" that is a typical Palmer product.
- Type: passive
- Number of channels: 2
- Number of inputs: 2
- Input connections: XLR Combo / 3.5mm stereo jack
- Input type: balanced/unbalanced
- Maximum input level: +20 dBu
- Input impedance: 10 kohms balanced/ 5 kohms unbalanced
- Number of outputs: 2
- Output connections: XLR/m, 3.5 mm stereo jack
- Output type: balanced/unbalanced
- Max output level: +20 dBu
- Output impedance: 600 ohms
- Frequency response: 10Hz - 40 kHz +/- 1 dB
- THD: 0,001 %
- Max. attenuation: 85 dB (attenuator), 112 dB (attenuator + mute)
- Controls: Attenuation, Mute, Mono
- Housing material: sheet steel/wood
- Housing surface: powder-coated
- Width: 164 mm
- Height: 62 mm
- Depth: 85 mm
|
- All-passive volume control circuit
- Stereo and AUX inputs
- Dual outputs
- Additional mono output
- Balanced and unbalanced connection
- Integrated high quality headphone amplifier
- Mono, mute and PFL switches
- Stereo volume, AUX and headphone level controls
- Elegant design with solid wood side panels
- Built to last
The Palmer Monicon® L is a precise, analogue volume control that connects between a computer or audio interface and active monitor speakers. The switch is completely passive and distortion-free, the LED displays and built-in headphone amplifier are powered via the included power supply.
Symmetric combo sockets serve as stereo input. The Monicon® L’s AUX input features RCA sockets and a 3.5 mm stereo jack. The compact console offers outputs for two monitor pairs and a mono summed output via XLR sockets. The stereo or AUX input can be selected alternately, the two outputs individually and together. In addition to its large volume controller, the Monicon® L is also equipped with mono, mute and PFL switches, a 6.35 mm headphone output, and separate AUX and headphone controllers for convenient operation.
Product type
Other Studio and Recording Equipment
Channels
2
Inputs
2
Input connectors
3.5 mm TRS , RCA , XLR
Input type
balanced/unbalanced (depending on TS/TRS connection)
Max. input level
20 dBu
Input impedance
(balanced) 10k Ohm(s) , (unbalanced) 5k Ohm(s)
Outputs
3
Output connectors
XLR
Output type
balanced/unbalanced (depending on TS/TRS connection)
Max. output level
20 dBu
Output impedance
600 Ohm(s)
Frequency response
10 - 40000 Hz
THD
0.001 %
Max. attenuation
(Attenuator + Mute) 112 dB , (Attenuator) 85 dB
Controls
attenuation , input selector , mono , mute , output selector , PFL source
Cabinet material
sheet steel , wood
Cabinet surface
Powder coated
Width
218 mm
Height
77 mm
Depth
100 mm
Weight
1,14 kg |
Πληροφορίες
Φορητός προενισχυτής (DAC) υψηλής ποιότητας 24bit/192kHz για ακουστικά. Σύνδεση USB με PC/Mac. Ενσωματωμένη τεχνολογία Constant Current Drive η οποία δίνει στα περισσότερα ακουστικά του εμπορίου ομοιόμορφο ηχητικό αποτέλεσμα με πλούσιο συχνοτικό εύρος, Quad Sum DAC τεχνολογία για χαμηλά επίπεδα θορύβου και εξάλειψη της παραμόρφωσης. Μέγιστη έξοδος 225mW στα 30 Ohm. Διαθέτει 2 knobs για την ρύθμιση της έντασης, 3 led για τις ενδείξεις της στάθμης και έξοδο ακουστικών. Ελαφρύ σώμα από αλουμίνιο. Κατασκευασμένο στις ΗΠΑ.
| Behringer HA-400 Ultra-Compact 4-Channel Stereo Headphone Amplifier
Mini to the max! You can use this super-compact stereo headphone amplifier with practically all headphones?four of them at the same time, to be exact! For example, you can let up to 4 different people in your studio listen to the main mix while the recording is being made, and each listener can determine his own volume level using the dedicated output level controls. The HA400 contains 4 high-power stereo amplifiers that maintain the highest sonic quality even at maximum volume levels. Ultra low-noise 4580 operational amplifiers are included for outstanding audio performance?these are the same op amps found in ?full-size? audio equipment?plus, a DC 12-Volt adapter is included.
If you are one of those musicians who like to deck out their equipment with lots of bells and whistles, the HA400 definitely makes a great addition to the functionality of your studio.
The Behringer HA400 offers flexible amplification for up to 4 headphones. Whether you're tracking a full band, playing to a backing track, or just listening to your mix, this compact amp gives every performer diverse volume control.
Hear everything with clarity. The HA400 promises high audio quality with zero interference, no matter what headphones you use. Behringer are relied upon by professional musicians everywhere. With the HA400 headphone amplifier, you'll become a part of 50+ years of innovation and expertise.
The Highest Quality Monitoring Possible
Great monitoring is at the heart of a tight performance. Whether you're on stage or in the studio, the HA4000 delivers ultimate control for everyone playing. Discover the highest quality audio from 4 high power, stereo amplifiers. Even at maximum volume, this tidy headphone amp provides clear sound without muddiness or unwanted noise.
Industry Leading Standard
There's a reason why Behringer are leaders in their field. With 50+ years of industry experience, they've built a legacy around exceptional build quality and innovative design. The HA4000 is no exception. Every channel preserves the original sonic qualities of your input signal. That's performance you can trust.
Features
- Ultra-compact headphone amplifier
- Ideal for stage or studio use
- Full control for every channel with 4 independent stereo high-power amplifier sections
- Extremely high audio quality with virtually all types of headphones, even at maximum volume
- 12V DC power adapter included
- Designed and engineered by Behringer in Germany
Specifications
Line Inputs
-
-
- Type: 1/4'' TS Jack, Stereo
- Impedance: 100kohms
- Max. input level: +15dBu
Headphone Outputs
-
-
- Type: 1/4'' TRS Jacks, Stereo
- Impedance: Approx. 80ohms
- Max. output level: Approx. 40mW in 100ohms
Power Supply
-
-
- Power supply: External power supply 12V
Dimensions/Weight
-
- Dimensions: 47mm (H) x 57mm (W) x 104mm (D)
- Weight: 0.32kg
|
Φορητός ενισχυτής Ακουστικών υψηλής ποιότητος. Διαθέτει 3 ανεξάρτητες εξόδους ακουστικών (1/4 TRS η μία μπορεί να είναι 1/8 TRS) με έλεγχο στάθμης στη κάθε μια, ένδειξη peak σε κάθε έξοδο, επιλογή λειτουργείας mono/stereo, 1 είσοδο Line XLR, 1 unbalanced είσοδο Line 1/4 TRS, 1 unbalanced είσοδο 1/8 TRS, έξοδο Loop για να συνδεθεί με άλλη HX- 3, έξοδο balanced TA3 line / tape, Λειτουργεί με 2 μπαταρίες ΑΑ η με εξωτερικό 5-18 VDC.
| Αριθμός Εισόδων | 0 | | Τύπος Εισόδου | | | Βύσμα Εισόδου | | | Προενίσχυση Μικροφώνου | | | Τροφοδοσία Phantom | | | Ενδεικτικά Όργανα | | | Αριθμός Εξόδων | 0 | | Τύπος Εξόδου | | | Βύσμα Εξόδου | | | Τροφοδοσία | | | Ιδιαίτερα Χαρακτηριστηκά |
|
Αξιολογήσεις
Δεν υπάρχει καμία αξιολόγηση ακόμη.