Content | 10g dj style 1/2”-mount cartridge headshell
This headshell for 1/2”-mount cartridges and 4-pin turntable arm (Audio-Technica, Technics, SME) features all-metal construction and an integral finger lift. It is equipped with a rubber washer for a secure fit to your tone arm, and comes with colour-coded headshell lead wires and cartridge mounting screws, nuts and washer.
- All metal construction with integral finger lift
- Rubber washer for secure fit to tone arm
- Color coded lead wires and cartridge mounting hardware
- No tilt adjustment
- No overhang adjustment of the headshell on the arm (cartridge overhang adjustment is provided by the two slots on the headshell)
|
Technical data
Quintet FrontMono01
Output voltage at 1 kHz 5 cm/sec 0.3 mV
Frequency range at -3 dB 20-25.000 Hz
Frequency response 20 Hz - 20 kHz +/-2.0 dB
Tracking ability at 315 Hz at recommended tracking force *) 70 μm
Compliance, dynamic, lateral 15 μm/mN
Stylus type Nude Elliptical
Stylus tip radius r/R 8/18 μm
Tracking force range 2.1-2.5 g (21-25 mN)
Tracking force recommended 2.3 g (23 mN) Quintet SideMono01
Tracking angle 20º
Internal impedance, DC resistance 5 Ohm
Recommended load impedance >20 Ohm
Cartridge body material ABS/Aluminium
Coil wire material Pure 4-nines silver/Ag
Cartridge colour White
Cartridge weight 9 g |
Pick your colour
Designed for the PLX-1000 and PLX-500, the PC-HS01 headshell comes in black, silver and gold so you can choose the colour that complements your set-up best. Or use the colours to differentiate between your weight, cartridge and stylus preferences; for example, black for scratching, silver for recording, and gold for listening.
The PC-HS01 comes with a 4 gram shell weight, but the headshell also allows you to attach different weights (cartridge and stylus are not included).
Specifications
|
- PC-HS01 includes:
- 2 screws
- 2 washers
- 2 nuts
- 4 gram shell weight
- Product weight: 10 g (11 g, including the supplied accessories)
- Shell length: 52 mm
- Finger length: 21 mm
|
|
15g TechniHard™ adjustable headshell with AT6101 quad wire
- Adjustable overhang and adjustable azimuth (tilt)
- Threaded headshell avoiding in use of nuts when fitting cartridge
- 7 pairs of installation screws (3mm, 5mm, 6mm, 8mm, 10mm, 12 mm and 14mm)
- 1 hexagon wrench (for overhanging and tilt adjustment)
|
Product information "Analogis Headshell"
This Headshell made out of light metal is a Technics-Replica.
|
18g TechniHard™ adjustable headshell with AT6101 quad wire
- Adjustable overhang and adjustable azimuth (tilt)
- Threaded headshell avoiding in use of nuts when fitting cartridge
- 7 pairs of installation screws (3mm, 5mm, 6mm, 8mm, 10mm, 12 mm and 14mm)
- 1 hexagon wrench (for overhanging and tilt adjustment)
|
Reviews
There are no reviews yet.