Content |
UHF-R handheld transmitters boast a rugged, lightweight construction and an antenna design which advances RF transmission reliability. The transmitter design allows for interchangeable microphone cartridges. The UR2 is offered with BETA 87A, BETA 87C, BETA 58A, SM86, SM87A, SM58, KSM9 and VP68. For use with UHF-R Wireless Systems. UHF-R Wireless features KSM9 as the premier choice in handheld vocal microphones. Switchable RF power Frequency and power lockout Bit-mapped backlit LCD 2 AA batteries -- up to 9.5 hours continuous use Infrared automatic transmitter sync All metal die-cast construction Interchangeable cartridges: SM58, SM86, SM87A, Beta 58A, Beta 87A, Beta 87C, KSM9, and VP68
|
The IR-200M is a handheld infrared wireless microphone. It eliminates problems with interference or eavesdropping, allowing simultaneous use in adjacent conference rooms or school classrooms. Since infrared wireless microphone system uses a frequency band that does not interfere with that of the TS-800 and TS-900 series infrared conference system, both systems can be simultaneously installed in the same location.
Battery | IR-200BT-2 rechargeable battery for the infrared wireless microphone (option)
or AA alkaline dry cell battery (2 pieces). | Current Consumption | Typ. 250 mA (2.4 V, Power selector switch: N)
Typ. 340 mA (2.4 V, Power selector switch: H) |
Infrared Emitter
Wavelength | 870 nm (AM: Brightness modulation) | Modulation Method | Frequency modulation | Carrier Frequency | Channel A: 3.100 MHz
Channel B: 3.350 MHz | Transmission Distance | Approx. 20 m (65 ft) (Power selector switch: H, in an unobstructed space)
Approx. 15 m (50 ft) (Power selector switch: N, in an unobstructed space) | Tone Signal | 32.768 kHz | Modulation Sensitivity | ±4.8 kHz (1 kHz, when SPL of 84 dB is input) | Maximum Input Sound Pressure | 120 dB SPL | Microphone Unit | Unidirectional electret condenser microphone | Frequency Response | 100 Hz - 12 kHz | Preemphasis | 300 μs | Battery Operation Time | Approx. 8 h (when the IR-200BT rechargeable battery for the infrared wireless
microphone is used, Power selector switch: N)
Approx. 6 h (when the alkaline battery is used, Power selector switch: N) | Operating Temperature | 0 ℃ to +40 ℃ (32 ゜F to 104 ゜F) | Operating Humidity | 30 % to 85 %RH | Finish | Control section: ABS resin, metallic gray, paint, 50% gloss
Filter section: Polycarbonate, optical cut filter | Dimensions | φ37 × 241.8 (H) mm (φ1.46" × 9.52“) | Weight | 170 g (0.37 lb) (with battery) | Accessory | Screw driver (for setting) …1, Color label (6 colors) …1 |
|
The FP1 Bodypack Transmitter features a lightweight and durable design for use with TA4F-connection microphones including lavaliers and headsets.
Ideal for use with FP Wireless and SLX Wireless.
FP Wireless Systems feature patented Audio Reference Companding for crystal-clear sound beyond the limits of conventional wireless technology.
Automatic transmitter setup that instantly syncs the transmitter to the receiver frequency
LED indicator for control lockout, IR RF sync, and low battery
Audio input gain for adjustment of audio level
4-Pin microphone input jack for use with lavaliers or headset microphones with TA4F connectors
Gain Adjustment Range
−10 to +20 dBV
Input Impedance
1 MΩ
RF Output Power
10 to 30 mW (varies by region)
Pin Assignments
TA4M
1: ground (cable shield)
2: + 5 V Bias
3: audio
4: Tied through active load to ground (On instrument adapter cable, pin 4 floats)
Dimensions
108 mm x 64 mm x 19 mm (H x W x D)
Weight
81 g (3 oz.), without batteries
Housing
Molded polycarbonate case
Power Requirements
2 AA batteries, 1.5 V
Battery Life
Up to 12 hours (alkaline)
|
Shure SLX2-BETA87C-R5 Wireless Microphone
Features:
Automatic Transmitter Setup
Backlit LCD with timeout feature
Frequency and power lockout
3-segment battery fuel gauge
2 AA batteries (included) provide 8 hours of continuous use
518 - 782 MHz operating range
Operating Range Under Typical Conditions
100m (300 ft.)
Note: actual range depends on RF signal absorption, reflection, and
interference
Audio Frequency Response (+/? 2 dB)
Minimum: 45 Hz
Maximum: 15 kHz
(Overall system frequency depends on microphone element.)
Total Harmonic Distortion (ref. +/? 38 kHz deviation, 1 kHz tone)
0.5%, typical
Dynamic Range
>100 dB A-weighted
Operating Temperature Range
?18°C (0°F) to +50°C (+122°F)
Note: battery characteristics may limit this range
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive voltage applied
to tip of WA302 phone plug) produces positive voltage on pin 2 (with
respect to pin 3 of low impedance output) and the tip of the high
impedance 1/4-inch output.
SLX1 Bodypack Transmitter
Audio Input Level
-10 dBV maximum at mic gain position
+10 dBV maximum at 0 dB gain position
+20 dBV maximum at -10 dB gain position
Gain Adjustment Range
30dB
Input Impedance
1 MΩ
RF Transmitter Output
30 mW maximum (dependent on applicable country regulations)
Dimensions
108 mm H x 64 mm W x 19 mm D (4.25 x 2.50 x 0.75 in.)
Weight
81 grams (3 oz.) without batteries
Housing
Molded ABS case
Power Requirements
2 ?AA? size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
SLX2 Handheld Transmitter
Audio Input Level
+2 dBV maximum at -10dB position
-8 dBV maximum at 0dB position
Gain Adjustment Range
10dB
RF Transmitter Output
30 mW maximum (dependent on applicable country regulations)
Dimensions (including SM58 cartridge)
254 mm x 51 mm dia. (10 x 2 in.)
Weight
290 grams (10.2 oz.) without batteries
Housing
Molded PC/ABS handle and battery cup
Power Requirements
2 ?AA? size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
SLX4 Receiver
Dimensions
42 mm H x 197 mm W x 134 mm D (1.65 x 7.76 x 5.28 in.)
Weight
816 g (1 lb. 13 oz.)
Housing
Galvanized steel
Audio Output Level (ref. +/? 38 kHz deviation with 1 kHz tone)
XLR connector (into 600 Ω load): ?13 dBV
1/4 inch connector (into 3000 Ω load): ?2 dBV
Output Impedance
XLR connector: 200 Ω
1/4 inch connector: 1kΩ
XLR output
Impedance balanced
Pin 1: Ground
Pin 2: (+)
Pin 3: (-)
Sensitivity
?105 dBm for 12 dB SINAD, typical
Image Rejection
>70 dB, typical
Power Requirements
12?18 Vdc at 150 mA, supplied by external power supply
| | Features
Automatic Transmitter Setup instantly syncs the transmitter to the receiver frequency
LED indicator for control lockout, IR RF sync, low battery indicator
Powered by 2AA batteries
SM58 or VP68 microphone capsule options
Additional microphone capsules available as accessories: VP68, Beta 87A, Beta87C, Beta 58A, SM86
Specifications
Transmitter Type: Handheld
Dimensions: 254 mm x 51 mm
RF Output Power: 10 - 30 (country specific)
Battery, endurance: 2AA, up to 12 h
Weight: 290 g |
Reviews
There are no reviews yet.