X VIVE GA-1 Acoustic Practice Amp

Dimensions:79.5 x 75.5 x 15.5mm
Weight: 40g
Controls: Gain, Tone, Volume; STANDBY/ON/FX switch
Terminals: Phone Jack/AUX In Jack

Specifications
General

Frequency response
    

 
    

20 Hz - 20  kHz (+0 dB, -1.5 dB)

Signal-to-noise ratio
    

 
    

100  dB (IHF A-weighted, input level control min.)

Channel separation
    

 
    

80 dB between adjacent channels

Line input
    

 
    

Front: 6.3 mm jacks, unbalanced
Rear: RCA connectors, unbalanced

   Input impedance
    

 
    

40 kOhm

   Nominal level
    

 
    

-10 dBV (0.3 V)

Headphone outputs
    

 
    

four 6.3 mm stereo jacks

   Maximum output power
    

 
    

2 x 1.5 W at 8 Ohm (1 channel in use)
2 x 1,2 W an 8 Ohm (four channels in use)

Power supply
        

230 V AC, 50 Hz

Power consumption
    

 
    

10 W

Dimensions (W x H x D)
        

482  mm x 44  mm x 196  mm

Weight
    

 
    

4 kg

The amPlug Twin rolls back the years to capture the sound of the legendary clean American dual speaker combo tube amp. Noted for its sparkling and sustained clean sound, this amp has been is widely used in many genres - rock, blues, jazz, country, and more. Raising the gain provides a powerful American tube overdrive sound. A stereo chorus effect is built into the amPlug Twin, adding natural spaciousness and depth to the sound. As you play these sounds, you're sure to forget the passage of time, and lose yourself in the tones loved by musicians in styles such as jazz, country, and blues.
Specifications

• Controls: Gain, Tone, Volume; STANDBY/ON/FX switch
• Terminals: PHONES Jack (stereo), AUX In Jack (stereo)
• Power supply: AAA batteries (x 2)
• Battery life: amPlug Twin (FX on):
• With zinc-carbon batteries: approximately 3 hours
• With alkaline batteries: approximately 11 hours
• Dimensions (W x D x H): 86 x 80 x 31mm/3.39" x 3.15" x 1.22“
• Weight: 40 g/1.41 oz. (not including batteries)
• Included items: AAA batteries (X2) (for verifying operation)

The PHDA02 - a reference class headphone amplifier with Stereo, Mono, and Dual Mono operation modes.

In Stereo mode, the L/R input signal is fed to the left and right earphones while the volume level is set by the Stereo/Left control. The front panel inputs provide simultaneous connection of two headphones in parallel. In Mono mode, the left and right channels are summed, and the resulting mono signal is fed to both the left and right earphones. Again, volume is governed by the Stereo/Left control. In Dual Mono mode, the left and right channels can be used independently with individual level controls for the left and right earphones.

The PHDA02 operates with all headphones with an impedance of 8 up to 200 Ohms. Impedance matching is achieved by a specially designed switchable transformer. Uncommon and costly, this solution provides superior performance, dynamic range, and signal-to-noise ratio at all loads.

Combo input sockets allow for balanced XLR and unbalanced TS headphone connection while parallel XLR outputs facilitate daisy chaining multiple units. The integrated power supply operates with mains from 100 VAC to 240 VAC.

The PHDA02 is equipped with low-noise op amps, and the output amplifiers' discrete power transistors are mounted on heatsinks. Dimensions are 1 U 9.5“.

The amPlug Night Train perfectly simulates the high-gain sound of the compact VOX Night Train tube amp. Just as with the actual Night Train head, you can switch between the two preamp sounds. The BRIGHT position boosts the high-frequency range; the THICK position offers a chunkier, heavier sound. The emulated speaker cabinet circuit accurately recreates the sound of the Night Train amp being played through the matching V112NT single 12" Night Train speaker cabinet. As a finishing touch, amPlug Night Train share some of the cool looks of its namesake amplifier.

• Controls: Gain, Tone, Volume; STANDBY/ON/FX switch
• Terminals: PHONES Jack (stereo), AUX In Jack (stereo)
• Power supply: AAA batteries (x 2)
• Battery life: amPlug Night Train:
• With zinc-carbon batteries: approximately 9 hours
• With alkaline batteries: approximately 24 hours
• Dimensions (W x D x H): 86 x 80 x 31mm/3.39" x 3.15" x 1.22“
• Weight: 40 g/1.41 oz. (not including batteries)
• Included items: AAA batteries (X2) (for verifying operation)