| Content | Perfect for speech, theater, orchestra and choir sound reinforcement and recording, the U853R cardioid condenser hanging microphone is equipped with UniGuard® innovations that offer unsurpassed immunity from radio frequency interference. With a consistent cardioid polar pattern, the mic offers natural sound from any angle, and superior gain before feedback. It is phantom powered and features an integral 80 Hz low-cut UniSteep® filter that reduces pickup of low-frequency ambient noise. The microphone accepts interchangeable elements, available in cardioid, hypercardioid, omnidirectional and UniLine® line cardioid polar patterns.
- Designed for suspension over choirs, instrumental groups and theater stages
- Superior off-axis rejection for maximum gain before feedback
- UniGuard® RFI-shielding technology offers outstanding rejection of radio frequency interference (RFI)
- UniSteep® filter provides a steep low-frequency attenuation to improve sound pickup without affecting voice quality
- Accepts interchangeable elements to permit angle of acceptance from 90° to 360°
- Low-profile design with low-reflectance finish for minimum visibility
- Available in two colors: black (U853R) and white (U853RW)
- Element: Fixed-charge back plate, permanently polarized condenser
- Polar Pattern: Cardioid
- Frequency Response: 30-20,000 Hz
- Low Frequency Roll Off: 80 Hz, 18 dB/octave
- Open Circuit Sensitivity: 39 dB (11.2 mV) re 1V at 1 Pa
- Impedance: 250 ohms
- Maximum Input Sound Level: 139 dB SPL, 1 kHz at 1% T.H.D.
- Dynamic Range: 115 dB, 1 kHz at Max SPL
- Signal to Noise Ratio: 70 dB, 1 kHz at 1 Pa
- Phantom Power Requiremens: 11-52V DC, 2 mA typical
- Switch: Flat, roll-off
- Cable: 25.0' (7.6 m) long (permanently attached to microphone), 0.13" (3.2 mm) diameter, 2 conductor shielded cable with TA3F-type connector
- Accessories: AT8153 two-stage foam windscreen; AT8451 steel hanger; AT8538 power module; AT8438 5/8“-27 stand adapter
|
- PA microphone with rugged, all-metal body
- Frequency response optimized for intelligibility
- Long useful life even in tough day-to-day usage
- Frequency response tailored to speech use
Rugged, affordable dynamic cardioid gooseneck microphone for general public address and communications use. The DST 99 S provides a frequency response tailored to speech use for optimum intelligibility as well as good offaxis rejection for high gain before feedback and suppression of unwanted ambient noise. The all-metal body ensures a long useful life for the microphone even in tough day-to-day use.
The DST 99 S is mounted on a table stand with an on/off switch and coiled cable with 3-pin XLR connector.
Ticket window, bank counter
Reception desk, restaurant
Houses of worship
Polar pattern cardioid
Frequency range 150-15,000 Hz
Sensitivity 2.2 mV/Pa (-54 dBV)
Max. SPL 133 dB (1% THD)
Equivalent noise level 21 dB-A
Signal/noise ratio (A-weighted) 73 dB
Impedance 530 ohms
Recommended load impedance >2,000 ohms
Connector 3-pin male XLR
Finish matte black
Net weight 805 g (1.8 lbs.)
Shipping weight 1,125 g (2.5 lbs.)
|
The evolution e 908 instrument microphone is available in four variants:
as e 908 D for drums and percussion
as e 908 B for wind instruments, congas, and drums with free-floating suspension system
as e 908 B ew for the wireless miking of saxophones using an evolution wireless instrument transmitter
as e 908 T ew for the wireless miking of trumpets using an evolution wireless instrument transmitter
- Pick-up pattern : cardioid
- Frequency response : 40 ... 20 000 Hz
- Sensitivity in free field, no load : (1kHz) 4 mV/Pa, 0,56mV/Pa (e 908T-ew)
- Equivalent noise level : e908B-ew = 30 dB(A); e908B & e908D = 35 dB(A), e908T-ew = 39 dB (A)
- Max. Sound pressure level (aktiv) : 147 dB
- Nominal impedance : 100 Ohm (e908B & e908D)
- Min. terminating impedance : 2000 Ohm (e908B & e908D)
- Phantom powering : 12 - 48 V / 3 mA (e908B & e908D)
- Weight : ca. 140 g
-
Dimensions : Ø 47 x 193 mm
|
AKG GN 30 OC., 12 inch gooseneck for D.A.M.-microphone capsules, 3/8“-connector, programmable indicator LED, incl. 10ft. cable to open-end, black, for installations |
Recommended For:
- Brass
- Drums
- Percussions
- Woodwinds
Features:
- Miniature condenser clip-on microphone for wind instruments, drums, and percussions
- Miniature gooseneck for accurate microphone alignment
- Including wireless direct adapter for easy use with AKG pocket transmitters
- Detachable microphone cable
- Transducer shock mount for high mechanical-noise rejection
Standard Accessories:
- A400 adapter
- Microphone bag
- W44 Windscreen
Specs:
- Polar pattern cardioid
- Frequency range 60 Hz to 20 kHz
- Sensitivity 5 mV/Pa (-46 dBV)
- Max. SPL 130/132 dB SPL (for 1 %/3 % THD)
- Equivalent noise level 31 dB(A)
- Signal/noise ratio (A-weighted) 63 dB
- Impedance = 2000 ohms
- Current consumption
|
- Low-profile floor stand gooseneck module - for permanent installations and mobile applications
- Extremely rugged gooseneck construction - for an extra-long life of reliability and stability
- Quick-absorbing rubber shock mount - for optimum suppression of structure-borne noise
- Highly reliable contacts for capsule modules prevent contact problems and ensure extra-long life
- Optional extension tube available raises the microphone for tall users or choir pickup
Elegant gooseneck module with heavy, shock mounted floor stand in matte gray finish for use with all Discreet Acoustics Capsule Modules. Integrated LED ring status indicator. Suited for stand-alone use on stage or in front of a lectern. Two integrated flexible gooseneck sections allow optimum alignment with talkers of different heights or positions. A supplied screw-on extension tube can be used to place the microphone higher for tall talkers. The supplied 10 m (33 ft.) cable with XLR phantom power adapter is long enough to reach the edge of most stages with no extension cable. For use as a lectern microphone in worship centers, halls etc.
Available capsule modules for GN 155 Set: CK 31, CK 32, CK 33, CK 47, CK 80.
| Bass filter |
250 Hz, -10 dB at 50 Hz |
| Impedance |
=2,000 ohms |
| Supply voltage |
9 to 52 V phantom power to DIN/IEC |
| Current consumption |
|
|
Reviews
There are no reviews yet.