ARTSOUND MG05 P-mount Κεφαλή CZ-800-10, CR-800, Για Πικάπ Numark , ΙΟΝ

• Grasp both sides of the stylus and pull forward to remove stylus
• Grasp both sides of the stylus and slide up and back to attach stylus

• Remove stylus from old Cartridge
• Grab headshell with thumb under front tab and index finger on rear of head shell with left hand.
• Grab old cartridge with right thumb and index finger. Carefully Pull down and forward with right hand while while pulling up with left hand.
• Carefully disconnect wires from rear of cartridge pulling from metal tabs.
• Remove stylus guard and stylus from new cartridge
• Connect wires on new cartridge. the single metal connector with black wires goes on the bottom posts that are closer together.
• From rear view, as you would install the cartridge - The red wire goes on the right upper post, the white wire goes on the left upper post.
• Reconnect cartridge to headshell by placing cartridge beneath headshell with thumb below cartridge and index finger on top of headshell.
• Carefully squeeze the two together. a 'light' snap occurs and the cartridge should fit snug.
• Reattach new stylus to new cartridge.

• Classic LP
• Max LP
• Mobile LP
• iPTUSB
• Archive LP
• Forever LP
• Live LP
• Power Play
• Quick Play Flash
• Quick Play LP
• Vinyl Motion
• Vinyl Motion Deluxe
• Air LP
• Duo Deck
• iLP
• LP 2 GO
• CD Direct
• iProfile
• Profile LP
• Profile Pro

For DJs that require increased tracking ability, the Scratch is up to the task. Featuring a reinforeced rubber suspension, DJs don't need to worry about compromising sound quality and stylus life when working with higher tracking forces. With solid bass reproduction and extended highs, the Scratch is great for any style, providing energetic, in-your-face sound.

This Ortofon Concorde Set contains;
- 2x Ortofon Concorde Scratch Element
- Ortofon Needle Brush
- All parts come in a special Ortofon box casing

Features:

For DJs that require increased tracking ability, the Scratch is up to the task.  Featuring a reinforced rubber suspension, DJs need not worry about compromising sound quality and stylus life when working with higher tracking forces.  With solid bass reproduction and extended highs, the Scratch is great for any style, providing energetic, in-your-face sound.  

Kεφαλή πικάπ με απόκριση συχνότητας  20 - 22,000Hz, output:6mV, Βάρος: 18.0g, και σφαιρική διαμαντένια βελόνα. 

For DJs that require increased tracking ability, the Scratch is up to the task.  Featuring a reinforced rubber suspension, DJs need not worry about compromising sound quality and stylus life when working with higher tracking forces.  With solid bass reproduction and extended highs, the Scratch is great for any style, providing energetic, in-your-face sound.

A budget cartridge that out performs a lot of other top-of-the-line models.

No need to go broke to get an affordable, tough-as-nails scratching tool.

Technical Data:

• Output voltage at 1000 Hz, 5cm/sec: 5 mV
• Channel balance at 1 kHz: 2 dB
• Channel separation at 1 kHz: 20 dB
• Channel separation at 15 kHz: 15 dB
• Frequency range at - 3dB: 20-20.000 Hz
• Frequency response: 20-18.000 Hz + 3 / - 2 dB
• FIM distortion at recommended
  tracking force, DIN 45.542:
• Tracking ability at 315Hz at
  recommended tracking force: 70 µm
• Compliance, dynamic, lateral: 7 µm/mN
• Stylus type: Spherical
• Stylus tip radius: R 26 µm
• Equivalent stylus tip mass: 0,5 mg
• Tracking force range: 3,0-5,0 g (30-50 mN)
• Tracking force, recommended: 4,0 g (40 mN)
• Tracking angle: 20°
• Internal impedance, DC resistance: 750 Ohm
• Internal inductance: 450 mH
• Recommended load resistance: 47 kOhm
• Recommended load capacitance: 200-600 pF
• Cartridge colour: Black
• Cartridge weight: 5 g
• Replacement stylus unit: PRO S