| Content |
Classic proportions combined with attractive styling and fresh ideas – the TLM 107 perfectly embodies the Neumann philosophy: Innovation based on tradition. Far from evoking vintage or retro nostalgia, the standard-setting TLM 107 represents an impressive, modern studio microphone. Its extensive performance spectrum and high-precision reproduction, very close to the original, make the TLM 107 universally applicable, opening up the widest freedom in mixing and post-production. |
| Acoustical operating principle | Pressure gradient transducer | | Directional pattern | Cardioid | | Frequency range | 20 Hz ... 20 kHz | | Sensitivity at 1 kHz into 1 kohm | 13 mV/Pa | | Rated impedance | 50 ohms | | Rated load impedance | 1000 ohms | | Equivalent noise level, CCIR1) | 23 dB | | Equivalent noise level, A-weighted1) | 12 dB-A | | Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL) | 71 dB | | Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL) | 82 dB | | Maximum SPL for THD | 110 dB | | Maximum SPL for THD | 129 dB | | Maximum output voltage for THD | -1 dBu | | Dyn. range of the mic. amplifier /A-weighted, 0.5 %2)) | 98 dB | | Dyn. range of the mic. amplifier /A-weighted, 5 %2)) | 117 dB | | Supply voltage (P48, IEC 61938) | 48 V ± 4 V | | Current consumption (P48, IEC 61938) | 3.2 mA | | Matching connector | XLR 3F | | Weight | 825 g | | Diameter | 78 mm | | Length | 165 mm |
1) According to IEC 60268-1; CCIR-weighting according to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2) Measured as equivalent el. input signal |
|
| A/B, X/Y, and M/S stereo recording
Ambience recording
Grand piano, woodwind and brass instruments
Percussions
Drums
Classical music recording
Studio applications
- Back-to-back large-diaphragm multi-pattern transducer
- True condenser technology
- High sensitivity and 155 dB maximum SPL capability
- Switchable 20 dB preattenuation pad
- Switchable bass cut filter
- Legendary, pristine AKG sound quality
- Complete with spider-type shock mount and aluminium carrying case
| Type |
Dual-capsule,1-inch large-diaphragm, true condenser pressure-gradient microphone |
| Polar pattern |
Cardioid, omnidirectional, figure-eight |
| Frequency range |
20 to 20,000 Hz |
| Sensitivity |
28 mV/Pa (-31 dBV) |
| Max. SPL |
135/155 dB SPL (0/-20 dB) for 0.5% THD |
| Equivalent noise level |
16 dB-A (IEC 60268-4) |
| Signal/noise ratio (A-weighted) |
78 dB |
| Preattenuation pad |
0 dB, -20 dB |
| Bass filter |
12 dB/octave, 300 Hz |
| Impedance |
=1000 ohms |
| Current consumption |
|
|
KSM44A Multi-Pattern Dual Diaphragm Microphone
Premium microphone with three polar pattern options (cardioid, omnidirectional, bidirectional).
Features - Prethos® Advanced Preamplifier Technology: Class A, discrete, transformerless preamplifier provides transparency, extremely fast transient response and no crossover distortion. Minimizes harmonic and intermodulation distortions.
- Groundbreaking specifications: 4dB of self-noise and max SPL of 131 dB for a total dynamic range of 127 dB – an increase of 7 dB that defines the new standard for cleanly nuanced audio capture
- Multiple polar patterns–cardioid, omnidirectional and bidirectional–for maximum flexibility in a wide variety of recording applications
- Dual 1 inch, externally biased, ultra-thin, 2.5 μm, 24 Karat gold-layered, low mass diaphragms provide superior frequency response
- Premium electronic components and gold-plated internal and external connectors
- Subsonic filter eliminates rumble from mechanical vibration below 17 Hz.
- Switchable 15 dB pad for handling extremely high sound pressure levels (SPLs)
- 3-position switchable low-frequency filter helps reduce unwanted stand vibration noise or counteract proximity effect
- Integrated three-stage "pop” protection grille reduces plosives and other breath noise
| Type | Condenser (externally biased) | | Frequency Response | 20 to 20,000 Hz | | Polar Pattern | Cardioid, Omnidirectional, Bidirectional | | lmpedance | 50 ohms | | Phantom power required? | 11–52 V DC phantom power (IEC-61938) 5.8 mA, maximum |
| Behringer C-2 2 Matched Studio Condenser Microphones
2 Matched Studio Condenser Microphones
- 2 matched condenser microphones for stereo studio recording and live applications
- Ideal as main and support microphones for studio and live applications
- Cardioid pickup pattern for effective feedback elimination
- Low-mass diaphragm for ultra-wide frequency response and ultimate sound reproduction
- Switchable low-frequency roll-off and input attenuation
- Ultra low-noise transformerless FET input eliminates low-frequency distortion
Excellent Source Isolation
Our C-2 mics also feature a low-frequency rolloff switch to eliminate infrasonics (mic handling noise, sound created by creaky stages), as well as a switchable -10 dB input pad to accommodate hot signals, such as a really loud vocalist or overzealous cellist.
The cardioid pickup pattern provides unparalleled sound source separation and feedback rejection. C-2 mics contain ultra low-noise transformerless FET input circuitry that can handle extreme dynamics with a maximum sound pressure level of 136 dB. So even if the featured performer at your next recording session or live show happens to be a revved-up jet engine, this workhorse mic will not distort!
Sound That Astounds
Every stitch of these mics is designed to deliver beautiful sound. Beginning with the gold-plated 3-pin XLR connector, you get the highest signal integrity.
Once connected to your system, youʼll notice these twin pro-caliber microphones have a 4 dB boost in the 1 kHz - 8 kHz range. For those of you new to condenser mics, this basically means youʼll get a slightly brighter sound that will give the perfect shape to cymbals and overhead miking. Acoustic pianos and choirs also benefit greatly from this type of frequency response.
Excellent Source Isolation
The cardioid pickup pattern provides unparalleled sound source separation and feedback rejection. C-2 mics contain ultra low-noise transformerless FET input circuitry that can handle extreme dynamics with a maximum sound pressure level of 136 dB. So even if the featured performer at your next recording session or live show happens to be a revved-up jet engine, this workhorse mic will not distort!
Our C-2 mics also feature a low-frequency rolloff switch to eliminate infrasonics (mic handling noise, sound created by creaky stages), as well as a switchable -10 dB input pad to accommodate hot signals, such as a really loud vocalist or overzealous cellist.
You Are Covered
We always strive to provide the best possible Customer Experience. Our products are made in our own MUSIC Group factory using state-of-the-art automation, enhanced production workflows and quality assurance labs with the most sophisticated test equipment available in the world.
As a result, we have one of the lowest product failure rates in the industry, and we confidently back it up with a generous 3-Year Warranty program. |
| Variable large diaphragm microphone | | Pressure-gradient transducer with double membrane capsule | | The studio microphone classic | | Three directional characteristics: omni, cardioid, figure-8 | | Switchable low frequency roll-off | | Switchable 10 dB pre-attenuation | |
Ideal as main and as support microphone in the most differing recording situations
| Acoustical operating principle | Pressure gradient transducer | | Directional pattern | Omnidirectional, cardioid, figure-8 plus | | Frequency range | 20 Hz ... 20 kHz | | Sensitivity at 1 kHz into 1 kohm | 20/28/22 mV/Pa1) | | Rated impedance | 200 ohms | | Rated load impedance | 1 kohms | | Equivalent noise level, CCIR2) | 26/23/25 dB1) | | Equivalent noise level, A-weighted2) | 15/12/14 dB-A1) | | Signal-to-noise ratio, CCIR2) (rel. 94 dB SPL) | 68/71/69 dB1) | | Signal-to-noise ratio, A-weighted2) (rel. 94 dB SPL) | 79/82/80 dB1) | | Maximum SPL for THD 0.5%3) | 117 dB (cardioid) | | Maximum SPL for THD 0.5% with preattenuation3) | 127 dB | | Maximum output voltage | 390 mV | | Dynamic range of the microphone amplifier (A-weighted) | 105 dB | | Supply voltage (P48, IEC 61938) | 48 V ± 4 V | | Current consumption (P48, IEC 61938) | 0.8 mA | | Matching connectors | XLR3F | | Weight | 500 g | | Diameter | 56 mm | | Length | 200 mm |
| |
Reviews
There are no reviews yet.