Content |
The evolution e 908 instrument microphone is available in four variants:
as e 908 D for drums and percussion
as e 908 B for wind instruments, congas, and drums with free-floating suspension system
as e 908 B ew for the wireless miking of saxophones using an evolution wireless instrument transmitter
as e 908 T ew for the wireless miking of trumpets using an evolution wireless instrument transmitter
Pick-up pattern : cardioid
Frequency response : 40 ... 20 000 Hz
Sensitivity in free field, no load : (1kHz) 4 mV/Pa, 0,56mV/Pa (e 908T-ew)
Equivalent noise level : e908B-ew = 30 dB(A); e908B & e908D = 35 dB(A), e908T-ew = 39 dB (A)
Max. Sound pressure level (aktiv) : 147 dB
Nominal impedance : 100 Ohm (e908B & e908D)
Min. terminating impedance : 2000 Ohm (e908B & e908D)
Phantom powering : 12 - 48 V / 3 mA (e908B & e908D)
Weight : ca. 140 g
Dimensions : Ø 47 x 193 mm
|
- Cardioid polar pattern
- 10 m (33 ft.) cable
- 125° pickup angle
- Especially suited for choir recordings
- Integrated spring steel clamp for optimum alignment
The new CHM 99 Condenser Hanging Microphone provides both ease of use and a high level of functionality. There is hardly any more affordable and simpler solution for recording choirs at worship centers. Suspended from the ceiling or a beam, the hanging microphone is aligned and then fixed in the correct position. Now use the spring steel clamp to adjust the correct angle, and off you go!
The CHM 99 is available in white or black.
XY stereo recording
Using two CHM 99 hanging microphones in an XY configuration (coincident pair) is a good way to make stereo recordings, particularly of choirs. However, sound source locations are defined only by intensity differences. Adjusting the angle between the microphones determines the width and depth of the stereo image.
ORTF stereo recording
Developed by the French Broadcasting Authority, this technique differs from the XY technique by recording not only intensity differences, but also delay differences. The capsules are aligned at an angle of precisely 110° and 170 mm / 6.7 in. apart.
Polar pattern Cardioid
Frequency range 70 to 18,000 Hz
Sensitivity 18 mV/PA = -35 dBV re 1 V/Pa
Max. SPL 125 dB (for 1% THD)
Equivalent noise level 73 dB
Impedance =2,000 ohms
Supply voltage 9 to 52 V phantom power to IEC 61938 (DPA adapter integrated)
Powering |
Recommended For:
- Brass
- Drums
- Percussions
- Woodwinds
Features:
- Miniature condenser clip-on microphone for wind instruments, drums, and percussions
- Miniature gooseneck for accurate microphone alignment
- Including wireless direct adapter for easy use with AKG pocket transmitters
- Detachable microphone cable
- Transducer shock mount for high mechanical-noise rejection
Standard Accessories:
- A400 adapter
- Microphone bag
- W44 Windscreen
Specs:
- Polar pattern cardioid
- Frequency range 60 Hz to 20 kHz
- Sensitivity 5 mV/Pa (-46 dBV)
- Max. SPL 130/132 dB SPL (for 1 %/3 % THD)
- Equivalent noise level 31 dB(A)
- Signal/noise ratio (A-weighted) 63 dB
- Impedance = 2000 ohms
- Current consumption
|
- PA microphone with rugged, all-metal body
- Frequency response optimized for intelligibility
- Long useful life even in tough day-to-day usage
- Frequency response tailored to speech use
Rugged, affordable dynamic cardioid gooseneck microphone for general public address and communications use. The DST 99 S provides a frequency response tailored to speech use for optimum intelligibility as well as good offaxis rejection for high gain before feedback and suppression of unwanted ambient noise. The all-metal body ensures a long useful life for the microphone even in tough day-to-day use.
The DST 99 S is mounted on a table stand with an on/off switch and coiled cable with 3-pin XLR connector.
Ticket window, bank counter
Reception desk, restaurant
Houses of worship
Polar pattern cardioid
Frequency range 150-15,000 Hz
Sensitivity 2.2 mV/Pa (-54 dBV)
Max. SPL 133 dB (1% THD)
Equivalent noise level 21 dB-A
Signal/noise ratio (A-weighted) 73 dB
Impedance 530 ohms
Recommended load impedance >2,000 ohms
Connector 3-pin male XLR
Finish matte black
Net weight 805 g (1.8 lbs.)
Shipping weight 1,125 g (2.5 lbs.)
| Polar pattern Cardioid
Frequency range 70 to 18,000 Hz
Max. SPL 125 dB (for 1% THD)
Equivalent noise level 73 dB
Impedance =2,000 ohms
Supply voltage 9 to 52 V phantom power to IEC 61938 (DPA adapter integrated)
Powering |
- Miniature cardioid condenser clamp-on microphone with shock mounted capsule, ideal for miking drums and percussions plus brass
- For use with the B 29 L battery power supply, MPA V L phantom power adapter, or PT 40 or PT 400 transmitters (AKG WMS bodypack transmitters)
- Includes an AKG W 44 Windscreen, an AKG A 518 stabilizer knee, a 5-ft. (1.5-m) plug-in connecting cable with 3-pin mini XLR connector, an A 400 adapter for attaching a PT 40 or PT 400 bodypack transmitter and a protective case
- Integrated gooseneck
- Continuously adjustable vice type clamp
- Type: pre-polarized condenser microphone
- Polar pattern: Cardioid
- Frequency range: 60 Hz to 20,000 Hz
- Sensitivity at 1 kHz: 5 mV/Pa (-46 dBV re 1 V/Pa)
- Impedance: = 200 ohms
- Recommended load impedance: = 2000 ohms
- Max. SPL for 1%/3% THD: 130/132 dB SPL
- Equivalent noise level: 31 dB(A) to DIN 45412
- Cable length / Connector: 1.5 m (5 ft.) / 3-pin mini XLR
- Finish: Matte black
- Size (microphone only): length: 200 mm (7.9 in.), max. width: 47 mm (1.9 in.)
- Net weight (microphone and cable): C 518 M: 220 g (7.8 oz.), C 518 ML: 110 g (3.9 oz.)
- Shipping weight: C 518 M: 450 g (15.9 oz.), C 518 ML: 330 g (11.7 oz.)
|
Reviews
There are no reviews yet.