Content |
The SLX1 bodypack transmitter is designed to hold up to the most adverse conditions. Whether used with headworn, lavalier, instrument microphones, or with guitars or basses, the SLX1 is the definition of reliability.
The SLX1 bodypack transmitter is designed to hold up to the most adverse conditions. Whether used with headworn, lavalier, instrument microphones, or with guitars or basses, the SLX1 is the definition of reliability.
- Automatic Transmitter Setup
- Backlit LCD with timeout feature
- Frequency and power lockout
- 3-segment battery fuel gauge
- 2 AA batteries (included) provide 8 hours of continuous use
- 518 - 782 MHz operating range
Audio Input Level
-10 dBV maximum at mic gain position
+10 dBV maximum at 0 dB gain position
+20 dBV maximum at -10 dB gain position
Gain Adjustment Range
30dB
Input Impedance
1 MΩ
RF Transmitter Output
30 mW maximum (dependent on applicable country regulations)
Dimensions
108 mm H x 64 mm W x 19 mm D (4.25 x 2.50 x 0.75 in.)
Weight
81 grams (3 oz.) without batteries
Housing
Molded ABS case
Power Requirements
2 "AA” size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
|
The IR-200M is a handheld infrared wireless microphone. It eliminates problems with interference or eavesdropping, allowing simultaneous use in adjacent conference rooms or school classrooms. Since infrared wireless microphone system uses a frequency band that does not interfere with that of the TS-800 and TS-900 series infrared conference system, both systems can be simultaneously installed in the same location.
Battery | IR-200BT-2 rechargeable battery for the infrared wireless microphone (option)
or AA alkaline dry cell battery (2 pieces). | Current Consumption | Typ. 250 mA (2.4 V, Power selector switch: N)
Typ. 340 mA (2.4 V, Power selector switch: H) |
Infrared Emitter
Wavelength | 870 nm (AM: Brightness modulation) | Modulation Method | Frequency modulation | Carrier Frequency | Channel A: 3.100 MHz
Channel B: 3.350 MHz | Transmission Distance | Approx. 20 m (65 ft) (Power selector switch: H, in an unobstructed space)
Approx. 15 m (50 ft) (Power selector switch: N, in an unobstructed space) | Tone Signal | 32.768 kHz | Modulation Sensitivity | ±4.8 kHz (1 kHz, when SPL of 84 dB is input) | Maximum Input Sound Pressure | 120 dB SPL | Microphone Unit | Unidirectional electret condenser microphone | Frequency Response | 100 Hz - 12 kHz | Preemphasis | 300 μs | Battery Operation Time | Approx. 8 h (when the IR-200BT rechargeable battery for the infrared wireless
microphone is used, Power selector switch: N)
Approx. 6 h (when the alkaline battery is used, Power selector switch: N) | Operating Temperature | 0 ℃ to +40 ℃ (32 ゜F to 104 ゜F) | Operating Humidity | 30 % to 85 %RH | Finish | Control section: ABS resin, metallic gray, paint, 50% gloss
Filter section: Polycarbonate, optical cut filter | Dimensions | φ37 × 241.8 (H) mm (φ1.46" × 9.52“) | Weight | 170 g (0.37 lb) (with battery) | Accessory | Screw driver (for setting) …1, Color label (6 colors) …1 |
|
96 CHN UHF TRUE DIVERSITY WIRELESS SYSTEM
The LD Systems WS 1000 G2 is an advanced 96 channel true diversity UHF wireless microphone system delivering natural sound with a wide dynamic range, high S/N ratio and low THD in both the 823 - 832 and 863 - 865 MHz bands. The WS 1000 G2 allows the use of up to 5 systems simultaneously and ships in various configurations. You can choose between dynamic or condenser handheld microphones, a beltpack transmitter with either a headset, lavalier-microphone, clip-on wind instrument microphone or guitar adaptor cable. It provides consistent audio transmission from 60 Hz to 16 kHz. Handhelds and beltpack feature convenient LCD indication of channel, group and battery status. Automatic channel scanning and the backlit multifunction receiver display facilitate system setup and operation. The operating time ranges up to 13 hours with high quality AA batteries. All WS 1000 G2 systems come with a rugged ABS plastic carrying case.
- Handheld with high-quality condenser capsule
- Convenient handling and channel setting via ASC
- LCD display of channel, group and battery status
- 2 AA batteries for up to 13 hours of operation
- Model name: LDWS1000G2MC
- Product type: Handheld microphone transmitter
- Radio frequency range: 823 - 832 and 863 - 865 MHz
- Channels: 96 (8 groups of 12 channels)
- Microphone type: condenser
- Directional characteristic: cardioid
- Audio frequency response: 60 Hz - 16 kHz
- RF output: 10 mW
- Controls: Power On/Off
- Indicators: LC display
- Power supply: 2 x 1.5 V AA
- Operating time: up to 13 hrs., battery-dependent
- Length: 252 mm
- Diameter: 50 mm
|
Shure SLX2-BETA87C-R5 Wireless Microphone
Features:
Automatic Transmitter Setup
Backlit LCD with timeout feature
Frequency and power lockout
3-segment battery fuel gauge
2 AA batteries (included) provide 8 hours of continuous use
518 - 782 MHz operating range
Operating Range Under Typical Conditions
100m (300 ft.)
Note: actual range depends on RF signal absorption, reflection, and
interference
Audio Frequency Response (+/? 2 dB)
Minimum: 45 Hz
Maximum: 15 kHz
(Overall system frequency depends on microphone element.)
Total Harmonic Distortion (ref. +/? 38 kHz deviation, 1 kHz tone)
0.5%, typical
Dynamic Range
>100 dB A-weighted
Operating Temperature Range
?18°C (0°F) to +50°C (+122°F)
Note: battery characteristics may limit this range
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive voltage applied
to tip of WA302 phone plug) produces positive voltage on pin 2 (with
respect to pin 3 of low impedance output) and the tip of the high
impedance 1/4-inch output.
SLX1 Bodypack Transmitter
Audio Input Level
-10 dBV maximum at mic gain position
+10 dBV maximum at 0 dB gain position
+20 dBV maximum at -10 dB gain position
Gain Adjustment Range
30dB
Input Impedance
1 MΩ
RF Transmitter Output
30 mW maximum (dependent on applicable country regulations)
Dimensions
108 mm H x 64 mm W x 19 mm D (4.25 x 2.50 x 0.75 in.)
Weight
81 grams (3 oz.) without batteries
Housing
Molded ABS case
Power Requirements
2 ?AA? size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
SLX2 Handheld Transmitter
Audio Input Level
+2 dBV maximum at -10dB position
-8 dBV maximum at 0dB position
Gain Adjustment Range
10dB
RF Transmitter Output
30 mW maximum (dependent on applicable country regulations)
Dimensions (including SM58 cartridge)
254 mm x 51 mm dia. (10 x 2 in.)
Weight
290 grams (10.2 oz.) without batteries
Housing
Molded PC/ABS handle and battery cup
Power Requirements
2 ?AA? size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
SLX4 Receiver
Dimensions
42 mm H x 197 mm W x 134 mm D (1.65 x 7.76 x 5.28 in.)
Weight
816 g (1 lb. 13 oz.)
Housing
Galvanized steel
Audio Output Level (ref. +/? 38 kHz deviation with 1 kHz tone)
XLR connector (into 600 Ω load): ?13 dBV
1/4 inch connector (into 3000 Ω load): ?2 dBV
Output Impedance
XLR connector: 200 Ω
1/4 inch connector: 1kΩ
XLR output
Impedance balanced
Pin 1: Ground
Pin 2: (+)
Pin 3: (-)
Sensitivity
?105 dBm for 12 dB SINAD, typical
Image Rejection
>70 dB, typical
Power Requirements
12?18 Vdc at 150 mA, supplied by external power supply
|
Artist Elite® AE3300 cardioid condenser capsule with integral shock mount Available in the following frequency bands: 541.500 - 566.375 MHz (C Band) 655.500 - 680.375 MHz (D Band) 721.500 - 746.375 MHz (G Band) 25 kHz frequency spacing makes it easier to find a clear, open frequency in crowded RF environments Two-stage pop filter to protect against "p” pops Dual output power selection to optimize battery life Digital Tone Lock™ squelch to identify the wireless transmitter to the receiver High efficiency dual companding system for flawless audio Function menu displayed in a backlit LCD window and controlled by internal touch switchesFour nameable user presets Operates on two AA batteries Battery fuel gauge LCD readout on the body of the microphone Power/mute lock provision Dual-colour power/mute status indictor 18 dB audio input level adjustment Integral capsule 6 dB pad switch Rugged metal housing with integral antenna Supplied with a heavy-duty microphone stand clamp RF Power Output: High: 35 mW; Low: 10 mW, nominal Spurious Emissions: According to National Regulations Dynamic Range: >=110 dB, A-weighted Microphone Element: Cardioid Condenser Batteries: Two 1.5V AA alkaline (not included) Battery Life: Approximately 6 hours (High); 8 hours (Low), depending on battery type and use pattern Dimensions: 239mm long, 50mm diameter Net Weight: 270g Accessory Included: AT8456a Quiet-Flex™ stand clamp
|
The FP1 Bodypack Transmitter features a lightweight and durable design for use with TA4F-connection microphones including lavaliers and headsets.
Ideal for use with FP Wireless and SLX Wireless.
FP Wireless Systems feature patented Audio Reference Companding for crystal-clear sound beyond the limits of conventional wireless technology.
Automatic transmitter setup that instantly syncs the transmitter to the receiver frequency
LED indicator for control lockout, IR RF sync, and low battery
Audio input gain for adjustment of audio level
4-Pin microphone input jack for use with lavaliers or headset microphones with TA4F connectors
Gain Adjustment Range
−10 to +20 dBV
Input Impedance
1 MΩ
RF Output Power
10 to 30 mW (varies by region)
Pin Assignments
TA4M
1: ground (cable shield)
2: + 5 V Bias
3: audio
4: Tied through active load to ground (On instrument adapter cable, pin 4 floats)
Dimensions
108 mm x 64 mm x 19 mm (H x W x D)
Weight
81 g (3 oz.), without batteries
Housing
Molded polycarbonate case
Power Requirements
2 AA batteries, 1.5 V
Battery Life
Up to 12 hours (alkaline)
|
Reviews
There are no reviews yet.